I hope this may save others from giving up or spend as many hours as I did.I solved this by pure lock and being stubborn, I don't know much about linux in general so if this don't work for you I can't be of further assistance. The GUI way to change font is still not working, If I open that it shows all fonts as size 12 and if I change any and hit apply or save the fonts are all reset back to 12, I conclude GUI font-setting is defective.ĭoing the work I also found two settings of fontsize 12 in the mgc_style.tcl file close to the end, but they do not seem to have any influence to GUI, properly only used in some tcl command mode. Modelsim-altera 6.5b Quartus Ii 9.1 Crack.
#Cannot launch modelsim altera how to
(Never spend enough time to figure out how to add fonts to ubuntu). font type sans-serif was changed to as fc-list showed that I do not have a font called sans-serif.
![cannot launch modelsim altera cannot launch modelsim altera](https://www.fpgakey.com/uploads/images/editor/20201127/1130511606447539(1).jpg)
![cannot launch modelsim altera cannot launch modelsim altera](https://smilingspider.files.wordpress.com/2013/01/msim.png)
textfonfV2 is set to -18 to fix the additional editor unvisible font. The small font was changed in the hidden file /home/peter/.modelsim line PrefDefault where I changed all 12 to 18 or 20. Setup environment variable MODELSIM to point to /home/peter and cp the modelsim.ini from the installation directory to /home/peter then do chmod +w modelsim.ini, second I set variable MODEL_TECH to point /home/peter/intelFPGA/17.1/modelsim_ase/bin this fixed the library problem. I found that beside running above instruction I had to do the following: PATH to modelsim was added by the installation script but other needed environment variables are NOT set as needed. Normally I start Modelsim in the folder where I want/have the work library. My problems may relate to the fact that I did not install Quartus only Modelsim-altera, but I do not thinks so.Īlso I do not use project files only do files to compile and simulate. Actually there where two problems, because modelsim did not read in all the standard libraries. ModelSim-Altera 6.6d (Quartus II Starter Edition: ModelSim-Altera 6. Finally after spending a lot of hours I managed to get it fixed. ModelSim-Altera 6.6d (Quartus II Starter Edition.